22
E-flite Eratix 3D 25e ARF Assembly Manual
5. Use a sharp hobby knife to cut the covering slightly
inside the lines drawn. Be very careful not to cut into the
underlying wood, as this will weaken the stab and cause
it to fail in flight.
Note
: You can use a soldering iron instead of a knife.
This will eliminate the chances of cutting into the wood.
6. Slide the elevator jointer into position, then
the stabilizer.
7 . Check the alignment and make sure everything lines
up. Wick thin CA into the joint between the fuselage and
stabilizer. Make sure to glue both top and bottom. Do
not use accelerator— to allow the CA to wick in the joint,
providing the best bond possible.
