11
E-flite P-38/F-5E Lightning Assembly Manual
7. Position the elevator servo in the servo tray on the
side with the "S9" decal with the output shaft towards the
front of the boom. Secure the servo using the hardware
provided with the servo.
8. Route the servo extension through the channel in the
bottom of the wing to the center fuselage.
9. Attach the receiver to the fuselage using the included
double-sided tape. Plug the elevator servo extension into
the elevator channel of the receiver.
Note
: Use the manufacturer's instructions for routing
your antenna. Never cut the receiver antenna as this will
greatly reduce the range of your radio system.
10. Turn on the transmitter and apply power to the
receiver. Check that the elevator servo is operating
properly. Center the elevator trim and control stick and
set any sub-trims to 0.
