12
E-flite Fokker DVII 250 Slow Flyer Assembly Manual
3. Slide a micro pushrod keeper onto the wire
extending through the control horn.
4. The pushrod keeper can now be snapped onto
the pushrod wire. You may need to use pliers to
apply enough pressure to snap the keeper onto
the wire.
5. Use a ruler to align the rudder and fin in the
neutral position.
6. Turn on the transmitter and make sure the rudder
stick and trim are centered. Use a #1 Phillips
screwdriver to tighten the 1.5mm machine screw
that will secure the pushrod wire in the pushrod
connector. Use threadlock on the screw to prevent it
from vibrating loose in flight.
7. Repeat Steps 1 through 4 to secure the elevator
pushrod to the center hole of the elevator control
horn with a micro pushrod connector.
8. Use a ruler to align the elevator and stabilizer in
the neutral position.
