10
E-flite Habu 32 EDF ARF Assembly Manual
16. Tie the end of the string around the end of the
aileron servo lead. Use the string to pull the aileron
servo lead into the flap servo bay.
17. Use four 2mm x 8mm self-tapping screws and
a #1 Phillips screwdriver to secure the aileron servo
cover to the wing.
18. Use a hobby knife with a #11 blade to trim two
1/4-inch (6mm) pieces from the silicone tubing.
Always use threadlock on metal-to-metal fasteners
to prevent them from vibrating loose.
19. Assemble the aileron linkage using the two
pieces of tubing from the previous step, two 2mm
nuts, two metal clevises and the 2mm x 25mm
threaded rod. The length of the rod will be adjusted
in the following steps.
20. Remove the tape holding the flap and aileron
in position. Use the radio system to center the
aileron servo. Connect the metal clevis to the inner
hole of aileron servo horn. The remaining clevis
connects to the aileron control horn. Adjust the
length of the linkage so the aileron is centered
when the servo is centered. Once the length of the
linkage has been adjusted, slide the tubing over the
forks of the clevises to keep them from accidentally
opening in flight. Use needle nose pliers to tighten
the nuts against the metal clevises.
21. Repeat steps 4 through 20 to install the
remaining aileron servo and linkage.
