15
E-flite Habu 32 EDF ARF Assembly Manual
21. Repeat steps 3 through 18 to install the
remaining flap servo and assemble the flap
linkage. Connect the flap linkage to the flap control
horn ONLY at this time.
22. Set the flap switch to the UP flap position.
Connect the linkage to the flap servo and adjust its
length until the flap is aligned with the aileron. This
will be the UP flap position.
You may have to fine-tune both flap linkages up
or down so they align at all three positions: up,
middle, and down. It is very important to use servo
arms positioned at the same angle on the splines of
the servo so the travel will match in all positions.
Wing Spar Installation
Required parts
Fuselage
Carbon wing spar (2)
8-32 x 1/4-inch socket head screw (4)
Wing panel assembly (right and left)
Required Tools and Adhesives
Low-tack tape
Phillips screwdriver: #1
15-minute epoxy
Mixing cup
Paper towels
Mixing stick
Epoxy brush
Rubbing alcohol
Ruler
Medium grit sandpaper
Petroleum jelly
Felt-tipped pen
Ball driver: 9/64-inch
1. Use a #1 Phillips screwdriver to remove the
four 2mm x 8mm screws that hold the fan cover to
the fuselage. Set the screws and cover aside in a
safe location.
2. Slide the canopy hatch pin rearward and lift
the canopy from the fuselage. The canopy is held
in place with two pins at the front. Set the canopy
aside so it doesn’t get damaged.
3. Use a 9/64-inch ball driver to start the four
8-32 x 1/4-inch socket head bolts in the aluminum
wing sockets inside the fuselage. Only thread the
screws in a few turns at this time. Use care not to
cross-thread the screws and damage the threads in
the aluminum sockets.