8
E-flite Habu 32 EDF ARF Assembly Manual
5. Use a pencil to draw two lines on the cover. The
first line is along the bottom of the cover, 3/32-inch
(2.5mm) from the edge. The second line is 7/8-
inch (22mm) from the side of the cover as shown.
This will center the servo horn in the slot when
using the recommended servos.
6. Sand the 10mm x 7mm end of the block using
medium grit sandpaper. This will be the end glued
to the plate in the next step.
7. Use 5-minute epoxy to glue the 13mm x 10mm
x 7mm hardwood block to the servo cover. Make
sure to glue the 10mm x 7mm end to the surface
of the plate. Allow the epoxy to fully cure before
proceeding.
8. Use a rotary tool and small sanding drum to
make a notch in the block for the servo lead. Check
the fit of the servo to make sure the servo lead can
clear the mounting block.
9. Position the aileron servo with the grommets
resting on the first mounting block and the servo
parallel to the line on the cover. Use a pencil
to mark the location for the remaining servo
mounting block.
10. Use 5-minute epoxy to glue the remaining
block to the cover. Don’t forget to roughen the end
of the block as shown in step 6.