9
E-flite LR-1A Pogo 15e ARF Assembly Manual
6. Use a #1 Phillips screwdriver to install the four
2mm x 12mm sheet metal screws to secure the
mount to the wing.
7. Follow the instructions provided with the servo to
install the rubber grommets and brass eyelets in the
servo mounting tabs.
Install the rubber grommets and eyelets in the
rudder and elevator servos at this time as well.
8. Place the aileron servo in the mount with the
output of the servo facing the leading edge of the
wing. Use a felt-tipped pen to transfer the locations
for the servo mounting screws onto the mount.
9. Use a pin vise and 1/16-inch (1.5mm) drill bit
to drill the holes through the mount and into the
wing. Use care not to drill holes through the bottom
of the wing.
10. Place 2–3 drops of thin CA in each hole to
harden the surrounding wood. This harder surface
makes the screws more secure when installed.
11. Place the servo back into the mount. Use a
#1 Phillips screwdriver to install the four screws
included with the servo to secure the aileron servo
in position.
When using a computer radio, it is recommended
to start with a new model that has been reset
to remove any sub-trims or programming.
