29
E-flite Ultimate 20-300 Assembly Manual
Upper Wing and Canopy Installation
Required Parts
Fuselage
Top wing
Bottom wing
Canopy
2mm nut (2)
2mm washer (4)
Interplane strut (2)
Machine screw, 2mm x 20mm (8)
Linkage, 7.5-inch (190mm) (2) Machine screw, 2mm x 6mm (2)
Pushrod connector backplate (2)
Lightweight pushrod connector (2)
2mm x 10mm machine screws (2)
Required Tools and Adhesives
Phillips screwdriver: #1
Pin drill
Drill bit: 1/16-inch (1.5mm) Low-tack tape
Adjustable wrench, small
Canopy glue
1. Use canopy glue to attach the canopy. Use
low-tack tape to keep the canopy in position until
the glue has fully cured.
2. Install the lightweight pushrod connector to the
interconnect horn. It may be necessary to enlarge the
hole in the interconnect horn on the bottom ailerons using
a pin drill and 1/16-inch (1.5mm) drill bit. Repeat for the
other aileron.