8
E-flite Ultimate 20-300 Assembly Manual
3. Position the hinges in the pre-cut slots in the
aileron. Slide the hinges into the aileron up to the
mark made in the previous step.
4. Slide the aileron in position with the hinges
inserted in the slots of the wing. Check that the end
of the aileron is aligned with the wing tip using a
straight edge.
5. Make sure the aileron does not bind at the center
of the wing.
6. Use a hobby knife with a #11 blade to set the
gap between the aileron and wing. The blade should
barely slide between the two surfaces. Doing so will
allow achieving the control throws listed with the
smallest gap possible.
