©2012 by e-Gizmo Mechatronix Central
N=L+"^"18"QR"7=L+0
EZ HMI Display Terminal
To change/enter parameter value
5T5T^" ]+3+<;";:+"7=/=9+;+/"2-9>+/"=0"K+0</.>+K".2"
5T5TQA5T5T?T
5T5TQU" C19+2;=/.34"7-0:";:+"+2<1K+/"0P.;<:"-2;.3"
;:+"ejf"9=/M+/"=77+=/0"12";:+">1;;19"3.2+"
rightmost position.
5T5TQQ" N/+00";:+"<-/01/"710.;.12"0P.;<:"]aY"ejf"1/"
]aB"ekf";1"710.;.12";:+"<-/01/";1";:+"K+0./+K"
digit position.
5T5TQ5" %1;=;+";:+"+2<1K+/"-2;.3";:+"K+0./+K"F=3-+".0"
displayed.
To Exit Parameter Entry Mode
5T5TQ?" C19+2;=/.34"7/+00"]a5"-2;.3"e]=F+"D:=2L
-
+0lf"9+00=L+"=77+=/0T"&:+"m+0([1(D=2<+3"
selection should also appear on the bottom
line.
5T5TQY" N/+00"<-/01/"0P.;<:"]aY"ejf"1/"]aB"ekf"
until the cursor coincides with the desired
response.
5T5TQB" N/+00"]a?";1"+2;+/";:+"<:1.<+"=2K"+c.;T
Exit Selection:
Yes
– To save all changes to non-volatile
memory
No
– To exit without saving to non-volatile
memory. The edited data will remain in effect
but will be reset to the last saved values once
;:+"71P+/".0"<4<3+K"6))";1"6[T
Cancel
"n"%+A+2;+/"7=/=9+;+/"+K.;"91K+T
Important:
The edit parameter mode exits with a
cleared LCD display. User application program must
reload the display to its previous condition upon
exiting this function. User application program can
detect this condition by using the
T
test function as
described in the communications section.
§ Tips:
!"&:+"212AF13=;.3+"9+91/4"<=2">+"/+P/.;;+2"-7";1"
QUU*UUU";.9+0T"
!"m1-/":10;"<12;/133+/"<=2"/+=K";:+"7=/=9+;+/"+F+2"
P:.3+".;".0">+.2L"=Kd-0;+KT"]++"0+<;.12"YTi"81/"91/+"
details.
P
MyParameter
10
Val:
3726
<
_
SW4 “<” OR SW5 “>”
TO MOVE CURSOR POSITION
]a5""""""]a?""""""j"]aY"""""]aB"k
Save Changes?
Yes/No/Cancel
_
