BRAKES
There are two types of braking mechanisms that e-JOE installs on its electronic bicycles, the “V-brake,” and the “Disk brake.” The
Epik SE has a Disk brake installed on both the rear and front brake and is used to control the entire braking system of the bicycle,
as shown in the picture below:
Brake Precautions
●
Do not brake too strongly or abruptly, as it will make it easier for you to fall down.
●
Remember which wheel is controlled by which brake.
●
Incline your body backward to reduce the influence of inertia.
●
Adjust the brakes properly. Brake pads gradually wear down normal use. If the brake pads are ground flat, repair or
replace them properly.
●
Check whether the braking function and braking power cut-off are working properly.
GEARS
The Epik SE comes with seven (7) gears. To change a gear, grasp the right end of the handlebar and twist up or down to your
desired gear.
●
The higher the gear number, the more resistance given when pedaling.
●
If you find that when using the Pedal Assist System you are moving faster than you can pedal comfortably, try moving to
a higher gear.