136
Figure 5-63
Please refer to the following sheet for detailed information.
Parameter
Function
Channel
Select speed dome connected channel.
Control
mode
You can select control mode from the dropdown list. There are two
options: Serial/HDCVI. For HDCVI series product, please select
HDCVI. The control signal is sent to the PTZ via the coaxial cable.
For the serial mode, the control signal is sent to the PTZ via the
RS485 port.
Protocol
Please select corresponding protocol from the dropdown list.
Address
Set corresponding dome address. Default value is 1.
Please note
your setup here shall comply with your dome address;
otherwise you can not control the speed dome.
Baud Rate
Select the dome baud rate. Default setup is 9600.
Data Bit
Default setup is 8. Please set according to the speed dome dial
switch setup.
Stop bit
Default setup is 1. Please set according to the speed dome dial
switch setup.
Parity
Default setup is none. Please set according to the speed dome dial
switch setup.
5.8.5.4 ATM/POS
The ATM/POS function is for financial areas. It includes Sniffer, information analysis and title overlay
function. The Sniffer mode is network.
The network type interface is shown as below. See Figure 5-64.
Here we take the ATM/POS protocol to continue.
There are two types: with or without the protocol according to client
’s requirements.
With the protocol
Summary of Contents for CJ-HDR104
