241
5.5 Image/Alarm-out
Select one monitor channel video and then click Image button in section 9, the interface is shown as
Figure 5-13.
5.5.1
Image
Here you can adjust its brightness, contrast, hue and saturation. (Current channel border becomes
green).
Or you can click Reset button to restore system default setup.
Figure 5-13
5.5.2
Alarm output
Here you can enable or disable the alarm signal of the corresponding port. See Figure 5-14.
Figure 5-14
5.6 Zero-channel Encode
Select a window and then click zero-channel encode button, the interface is shown as below. See Figure
5-15.
Summary of Contents for ELI-SIP2-NVR8
