129
4.5.7
Built-in Switch Setup
The built-in switch function is for product of PoE port.
From Main menu->Setting->Network->Switch, you can set switch IP address, subnet mask, gateway and
etc. See Figure 4-26.
Figure 4-26
4.6 Preview
After device booted up, the system is in multiple-channel display mode. See Figure 4-27.Please note the
displayed window amount may vary. The following figure is for reference only. Please refer to chapter 1.3
Specifications for the window-amount your product supported.
Figure 4-27
4.6.1
Preview
Summary of Contents for ELI-SIP2-NVR8
