H700 User Manual
E-Lins Technology Co.,Limited
Tel: +86-755-29230581 E-mail: sales@e-lins.com www.e-lins.com
from 1 to 32.
HTTP port
: set HTTP port, the default port is 80.
HTTP access from WAN
: allow or deny access router web management page from remote
side.
Remote network
: Any IP Address, Single IP address, Subnet.
IP address
: fill a remote IP address that can access router web management page.
Netmask
: 24 means net mask 255.255.255.0, 32 means 255.255.255.255, the illegal value is
from 1 to 32.
RFC1918 filter
: reject requests from RFC1918 IPs to public server IPs
3.6.9 Static Routes
Interface:
You can choose the corresponding interface type.
Target:
the destination host IP or network.
IPv4-Netmask
: the destination IP mask.
IPv4-Gateway
: IP address of the next hop.
Metric
: used by router to make routing decisions.
MTU
: maximum transmission unit
Table
: the route table ID, the default value is 254, valid table ID 1-254.
Notice:
Gateway and LAN IP of this router must belong to the same network segment.
If the destination IP address is the one of a host, and then the Netmask must be
255.255.255.255.
If the destination IP address is IP network segment, it must match with the Netmask. For
example, if the destination IP is 10.0.0.0, and the Netmask is 255.0.0.0.
