9
Bend coil
terminal 90
degrees.
b)
Use the Crimp Tool to trim 1” of shielding from the wire end.
Use the
largest opening on the tool stripper (position “10”) to GENTLY cut the
shield. Make one cut, and then a second cut with the tool rotated 90
degrees to ensure you cut the insulation all the way around the core. You
can then twist the trimmed wire shield to complete the separation.
Continue twisting as you remove the shield from the core.
c) Free the terminals from their strips with wire cutters.
d) Fold the wire core back against the shield and position in the crook of the
terminal ears, and “Pre-Crimp” the terminal. Pre-Crimping will snug the
ears against the wire shield (for positioning) and point the tips of the ears
inward just enough so they fit in the “W Crimp” slot on the tool.
e) “Final Crimp” the terminal using the “W
Crimp” slot on the Crimp Tool. The ears
feed into the side that has the “W” point.
This way the ears will roll back toward
each other and imbed themselves in the
shield as the Final Crimp is formed.
Core wire is
folded back.
Pre-Crimp
jaws are
near tool
hinge.
