UC305W User Guide
UCx 4.5
11-Feb-2015
Page
of
17
35
Copyright © 2014 E-Metrotel
Global Inc.
6 Connecting to Network
6.1 Connecting to Network
From the menu, select the "Access Points" icon. A list will be shown of the available stored networks or
Access Points (AP). A maximum of 4 can be stored. The bottom choice in the list is always "Search for
AP's". By selecting this option, your UC305W will search for AP's and lists the results. By pressing "Connect"
at a selected AP in the search result list the UC305W will try to connect to the AP. If necessary a key should
be entered by the user. After connection it will be saved as a profile and the user is asked to set this as the
default connection. By confirming it will search and connect to this network automatically next time the
UC305W is powered on. If there are already 4 AP profiles stored in the phone and another one is connected,
then it will ask the user which profile to replace.
6.2 Roaming
During a call it may be necessary to connect to another AP with a better signal before the connection is lost;
otherwise the call may be terminated. With roaming, the UC305W associated to an AP will switch over
automatically to another AP with the same SSID and same authentication key. With different
During a call, the
firmware?UC305W can be in idle mode (not in a call) or in a call (with call hand-over).
Received Signal Strength Indicator (RSSI) is measured continuously, if it is getting too low, phone will scan
for other AP's. If an AP is found with the same SSID but with another BSSID and a stronger RSSI value,
then the phone will try to connect to it. During this process the call will be temporarily interrupted for as long
as it takes to reconnect. All found AP's with the same SSID are shown in the results and displayed as a
single AP network.
