3 из 6
USER MANUAL
Made in a lab
E-Mode.pro
www.E-Mode.pro
Made in a lab
E-Mode.pro
www.E-Mode.pro
Humidity sensor installation
Place the humidity sensor plug into the slot. Then place the sensor into the
substrate and setup an optimal humidity level.
Read before use
Soil or substrate in a grow bag/pot can be relatively divided into three
layers.
1 st – surface layer (it loses moisture very quickly, part of water/solution
naturally goes lower to the 2 nd and 3 rd layers).
2 nd – interlayer (it is located between the dries and the moistest layers),
as a rule root system starts developing right here , and only later in the 1st
and 3rd layers.
3 rd – moistest layer, about 30% of water gets there 15 minutes after
watering.
1. Operating mode is on when the device is plugged in (220V).
2. Connect the humidity sensor to the device.
3. Place the humidity sensor into soil (substrate) to see the current humidity level (%) on the display.
4. Plug the pump or electromagnetic valve into SensiRoom h. socket.
5. Setup necessary humidity level, watering time, and watering intervals.
Device connection
GROWBAG
WATER
GROWBAG
GROWBAG
GROWBAG
GROWBAG
GROWBAG
HUMIDIT
Y SENSOR
220 V
