E-Mu 1212M Owner'S Manual Download

Page: 84 / 144

5 - Effects
Core Effects Descriptions

Creative Professional

Attack, Decay and Release times are all adjustable, and the shape of each of these
segments is selectable between exponential, linear, or logarithmic. An additional Hold
Time can be used to extend the Sustain phase past the point where the signal has passed
the Release Threshold.

If the Sustain Level is set the same as the Release Level, then the Reshaper effectively
becomes a two-phase “transient catcher” where the Release Threshold, Hold Time and
Release Time are ignored.

While the peak Attack gain level is always fully turned on, note that the Release Level is
not necessarily completely off, but can be adjusted upward so that the Reshaper retains
a nominal minimum gain. This allows the Reshaper to resculpt only the louder
transients of a signal while maintain a nominal output signal level the rest of the time.

The Release Threshold is always expressed relative to the Attack Threshold so that they
will automatically track each other when the Attack Threshold is adjusted.

Parameter

Description

Attack Threshold

When the input signal rises above the level set by the Attack Threshold
parameter, Reshaper's ADSR engine begins the Attack phase. The turn-
on threshold is adjustable anywhere between
-40dB and 0dB (below the PatchMix nominal operating point of
-12dBFS.)

Attack Time

This parameter controls the time, in milliseconds, that is required during
the Attack phase for the gain rise from its quiescent Release Level to
unity gain, or 0dB.

Decay Time

This parameter controls the time, in milliseconds, that is required for the
gain to fall from 0dB down to the attenuated Sustain Level. Note that if
the Sustain Level is set to 0dB this decay time becomes simply a delay
before entering the Sustain phase.

Release Time

This parameter controls the time, in milliseconds, that is required for the
gain to fall from the Sustain Level down to the Release Level.

Level Meter

This meter represents the input signal level in dB, and is in fact the
output of the Gate's envelope follower. Since the envelope follower is
driven by the greater of the left or right channel, this monophonic
meter represents the greater of the two input signals.

Sustain Level

This sets the gain level applied to the input signal when the ADSR
engine is in the Sustain phase.

Release Level

This sets the final gain level applied to the input signal when the Release
phase is fully decayed. When set to the minimum (-70dB) the effective
Release Level is -infinity, i.e., fully turned-off.

Hold Time

This parameter allows additional time to be added onto the Sustain
phase after the input signal falls below the Release Threshold before
transitioning to the Release phase. This extension of the Sustain phase is
useful for altering the tail dynamics of the sound.

Attack
Lookahead/Delay

This parameter is adjustable in milliseconds to allow the Reshaper to
either “look ahead” and advance (negative values) or “delay” (positive
values) the response of the envelope detector relative to the dynamics of
the input signal.
For example, negative lookahead values can cause the envelope
detector to start the ADSR's Attack phase before the actual attack of the
signal so as not to miss any audible transients. Likewise, positive delay
values can be used to start the Attack “late”, so that signal transients are
intentionally missed by the Attack.