5 - Effects
Core Effects Descriptions
94
Creative Professional
Gate
This parameter enables automatic gain reduction on signals that fall from 1 to 120dB
below the Threshold point (or Soft Knee threshold, if enabled.) This can act effectively
as a “noise gate” on low-level signals that have been boosted by the action of the Gain
or Soft Knee parameters. The gating action follows a somewhat soft-kneed contour of its
own so that turn-on and turn-off at the gate threshold is not too abrupt.
Note that, strictly speaking, the term “gate” is a misnomer in this context, since the
action of this parameter is simply to cancel out gain increases that resulted from the
settings of other parameters. This can be seen by the arrows in the diagram as the gain is
reduced below the Gate threshold back down to the dotted line representing unity gain.
The result is that if the Gain parameter is set negative or the Soft Knee parameter is
disabled, the Gate parameter will have no effect.
Comp Lookahead/Delay
This parameter controls compressor
lookahead or delay by setting the
relative time offset, in milliseconds,
between the compressor's signal path
and its sidechain path.
At negative values, this parameter lets
the level detector in the compressor's
sidechain “look into the future” up to
100 milliseconds in order to antic-
ipate upcoming peaks in the signal -
accomplished of course, by inserting
delay into the signal path. This
lookahead technique allows the use
of slower attack times without
missing signal peaks.
At positive values, the signal path delay is zero; instead, a delay of up to 50 milliseconds
is inserted into the sidechain path containing the level detector. This delay can be used
intentionally to cause the compressor to miss signal peaks, retaining the “punch” and
0dB
-10dB
-20dB
-30dB
-40dB
-50dB
-60dB
-70dB
-80dB
Threshold: -20dB
Ratio = 4:1
Gain = +15dB
Gate
Gate
Threshold
-30dB
In this example, the Gain has been boosted by +15dB. The Gate cancels out the +15dB Gain
boost below the Gate Threshold. Signal levels above the Gate Threshold will be boosted;
signal levels below this point will not be boosted and will be 15dB lower in volume.
Lookahead
Delay
Sharp waveform peak is missed by compressor.
Add Lookahead (neg values) to compress peak.
Add Delay (pos values) to allow peak through.
Summary of Contents for 1212M
