80
E-MU Systems
Controllers Menu
MIDI Footswitch Assign
Note:
Controllers 7 and 10 are already assigned to Volume and Pan for each
MIDI channel. Controllers 91 & 93 are the standard controller numbers for
reverb and chorus send amounts, but are not assigned.
Following are a few of the standardized MIDI Controller numbers as
defined by the MIDI manufacturers association. The controllers shown in
Bold
are automatically routed to the destination (volume & pan) or have
their own PatchCord source. Others, such as Portamento Time, can be
routed using a PatchCord to have the desired effect.
MIDI Footswitch
Assign
Like the MIDI Controllers, you can assign three MIDI footswitches to MIDI
footswitch numbers. Footswitches numbers are from 64-79. Destinations
for the footswitch controllers are programmed in the PatchCord section of
the Preset Edit menu. The rear panel footswitch 1 is connected to
footswitch controller 1 in this screen. Pressing the footswitch transmits on
the MIDI controller number programmed here. Footswitches 2 & 3 route
incoming MIDI footswitch data to the PatchCord section of MK-6.
Calibrate Controllers
This screen allows you to calibrate the Pitch Wheel, Modulation Wheel,
Aftertouch, and Foot Pedal controller. The controls should be recalibrated
periodically in order to compensate for normal changes in the controls
themselves. If a control doesn’t seem to be responding properly, it may
simply need to be recalibrated.
The Controllers should
ALWAYS be calibrated after you
reinitialize user data. (And you
should always reinitialize user
data after updating the
operating system.)
1 - Modulation Wheel
2 - Breath Controller
4 - Foot Pedal
5 - Portamento Time
6 - Data Entry
7 - Volume
8 - Balance
9 - Undefined
10 - Pan
11 - Expression
FOOTSWITCH CONTROLLER #
1: 64 2: 65 3: 66
Rear panel footswitch input
CALIBRATE CONTROLLERS
Start Mod Wheel
