RFX-32 Plug-ins
7
RFX-32
RFX Flanger
internal flanging stages when the Flange Mult
parameter is set greater than x1, and creates a warbling
or phasing effect on the output.
When the Sweep Source is set to MIDI, the Sweep Shape
parameter still controls the shape of the mapping
between the MIDI modulation value and the flanger
delay and whether the flanger is in Dual mode.
Selecting different Sweep Shapes in this mode can help
tune the MIDI controller contour to maximize its
‘playability’.
MIDI Controls
Wet/Dry Mix
FX Input Level
FX Output Level
Flange Delay
LFO1 Sweep Rate
LFO2 S/H Rate
S/H Trigger
LFO Resync
Feedback
Feedback
Feedback increases the depth of the cancellation
notches and generally intensifies the flange effect. This
parameter controls the amount of flanged signal which
is recirculated through each stage of the flanger, from 0
to 100%. It also sets the maximum feedback level which
is further modulated by the Feedback Modulation
parameter.
_
_
_
_
Use extra caution with
your sound system and hearing
when operating the RFX Flanger
at high feedback levels.
While the flanger is stable up to 100% feedback, it is still
possible to produce clipping within the flanging stages
and high output levels when the feedback level
approaches 100%. The amount of throughput gain can
also vary greatly depending on which Flange Mult
values and Flange Mode cancellation types are selected,
and where the LFO is in its sweep.
Many interesting tonalities such as bell tones, log
drums, resonant pipes, robot voices, and plucked string
sounds can be produced using high feedback values.
Flange Mult
This parameter controls a “multiplier factor” for the
flanger, changing the number and patterns of cancella-
tions produced by the different flanger stages. The sonic
result of different multiplier values is difficult to
describe, but the general effect is to intensify the
flanging at higher values of the Flange Mult parameter.
T r i a n g l e
C u r v e d
S q u a r e
S i n e
L o g
