39
07/10
6. Safety Information
In case of damage caused by non-compliance with these safety instructions the warranty / guarantee
will become void. We do not assume any responsibility for consequential damage!
We do not assume any liability for damage to property or personal injury caused by improper use
or the failure to observe the safety instructions! In such cases the warranty/guarantee is void.
Normal wear and tear during operation (e.g. worn-out gear wheels or servo transmission) are
excluded from the guarantee and warrantee, the same applies to accidental damage (e.g. broken
bearing retainer or rotor blades).
Dear customer, these safety instructions are not only for the protection of the product but also for your own
safety and that of other people. Therefore, read this chapter very carefully before putting the product into
operation!
a) General Information
• The unauthorized conversion and/or modification of the product is prohibited for safety and approval reasons (CE).
• The product is not a toy and should be kept out of reach of children under 14 years of age.
• The product must not become damp or wet.
• If you do not have sufficient knowledge yet of how to operate remote-controlled models, please contact an experienced
model sportsman or a model construction club.
• Taking out private liability insurance is recommended. If you already have one, get some information on whether or
not the operation of a model is covered by your insurance.
• Do not leave packaging material unattended. It may become a dangerous toy for children.
• Should there be any questions that are not answered by operating manual, contact us or another expert.
The operation and use of remote control model helicopters has to be learned! If you have never steered such a
model, start especially carefully and get used to the reactions of the model to the remote control commands first. Do
be patient!
b) Before Operation
• Always switch on the transmitter first and then connect the helicopter flight battery to the receiver/control component
at once. Since a frequency check (binding) between transmitter and receiver was already performed in the factory,
your model will react at once to your transmitter's control signals.
• Check the functional reliability of your model and of the remote control system. Watch out for visible damage such as
defective plug connections or damaged cables. All moving parts of the model must run smoothly, but should not
have any play in their bearings.
• Charge the flight battery, which is necessary for operation, as well as the rechargeable battery needed in the remote
control according the instructions indicated by the manufacturer.
• As power source for the plug-in mains adapter, use a 230V/50 Hz mains socket of the public mains only. Never try to
operate the device using any other voltage.
