26
27
❙
STEP 5
MARK OUT THE AREA TO BE FLASHED
• Mark out the area to be flashed with the help of the
pen
,
by tracing parallel white lines on the large areas.
• If necessary, use the guide plate
stop
to cover a rather
large area that should not be flashed (tattoos...).
• Cover small areas that should not be flashed (moles...)
with the
patches
.
• After applying a thick layer of
gel
over the entire area to
be flashed, move the applicator along the marked out area
(refer to the next page to know how to issue a flash).
• The applicator’s positioning leaves a ‘foot print’ on the
skin, which enables you to see the area that has just been
treated. Thus, from one flash to another, it is very easy to
distinguish between an area that has already been flashed
and another area that has not yet been. An overlap of about
1 mm is possible.
• Apply a thick layer of
gel
over the entire area to be
flashed. It must,
under no circumstance,
enter inside the
mobile head.
REMINDER:
The pencil of work
pen
, the
gel
, self-adhesive
patches
, the guide plate
stop
, the safety glasses
mask
to be used must be those supplied with your
.
The use of any other product may cause skin burns and
void the warranty of your device.
PRECAUTIONS TO BE TAKEN DURING THE SESSION
• You shall wear your
mask
safety glasses at all times. If other people are around you while you are using
, they
should also wear the
mask
safety glasses.
IMPORTANT:
Do not flash the periocular area (located under the
mask
safety glasses protecting your eyes, eye-
brows, eyelashes...).
• If you are planning to flash a large area, do not apply the
gel
over the entire area from the beginning: as it will dry
out and lose its effectiveness in terms of optical transmission. Therefore apply the
gel
as you progress onto the area
concerned. Once the
gel
has been used on the skin and has been flashed, it should under no circumstance, be collected
and reused on another area: flashing the
gel
is likely to cause a change in its optical characteristics.
TIP!
To easily remove the applicator from its base, you must grasp it next to the large white cable. The
applicator is then easily unhooked.
REMOVING HAIR WITH
