28
29
20
21
❙
STEP 6
ENDING THE SESSION
• Press key
1
.
• Once the fan located inside the applicator is off (after
10 minutes or so), the power cord can be unplugged.
The
other fans, located inside the base of
will only
stop once the device is unplugged.
• Clean the glass tip of the applicator (optical guide) with
a damp cloth.
• Finish cleaning the optical guide with the spray
clean
(images
20
and
21
).
Once you have completed your treatment with
,
you must wait for the fans located inside the applicator
to turn off completely. This enables, among other things,
the optical parts to cool down properly. The fans located
in the base, for their part, only stop when the device is
unplugged.
• Store your
.
NOTE:
After the hair removal session, small red spots may appear: this is a normal reaction and will disappear
quickly. In case of sensitive skin, and after a hair removal session with
do not use any hair removing
cream, for a whole week, on the areas that have been flashed.
ISSUING A FLASH
- To be able to flash, the glass tip of the applicator (optical
guide) must be applied onto the skin. Then pressure should
be exerted so as to “push down” the head of the applicator,
creating a pressure on the skin.
- The flash can then be triggered, by pressing the button
located on the side of the applicator.
- The pressure must be released and the applicator must be
moved away from the skin.
- The applicator is then moved onto the next area just beside
the one that has just been flashed. It can only be triggered
again after the indicator light has turned green (if the appli-
cator is triggered again before the indicator light has turned
green, you will not be able to issue the flash).
- Make sure that you stretch the skin where it is the thinnest,
so that the glass tip (optical guide) of the applicator is in
contact with the skin and that you have properly removed all
hairs from the area to be flashed.
14
15
16
17
18
19
NOTE:
For each flash, the treated area corresponds to the
range covered by the tip of the optical guide, i.e. 3 x 2 =
6 cm
2
. The glass surface (optical guide) at the tip of the
applicator must be placed
well flat
on the skin.
NOTE:
If the device remains idle for 10 minutes or so, it will automatically activate the energy saving mode.
The fans located inside the applicator will stop running, unlike those located inside the base: these will only
stop once the device has been unplugged. For the fans to be reactivated, you simply need to issue a flash.
Once the hair removal programme has started, the device charges itself: vertical bars scroll at the bottom of the
touch screen, from right to left (where icon (
22
)
is located). It also charges after each flash and precedes the display
of the number of remaining flashes on the
optic
cartridge.
If the device is idle for 15 minutes, it will automatically
go into “pause” mode.
REMOVING HAIR WITH
