17
86
24-16AWG
ETHERNET2 RX-
Ethernet communication port 2
Pin
Cross
section
Name
Description
87
24-16AWG
ETHERNET2 TX-
Ethernet communication port 2
88
24-16AWG
ETHERNET2 RX-
Ethernet communication port 1
89
24-16AWG
ETHERNET1 TX-
Ethernet communication port 1
90
24-16AWG
Power ground
Battery -
91
24-16AWG
Power ground
Battery -
92
24-16AWG
Output 21D
High side with diode
(1) PWM, half and full bridge only possible via ECU slaving.
(2) H-bridge control only with neighbouring output pairs (1+2, 3+4, 5+6, 7+8, 9+10).
(3) Calibration for waking the module with high signal. Dedicated wake pin is always active.
The SCS3000-16 is protected against false polarization at the main connection and load outputs.
4.2.5 Pin assignment SCS3000-48
The following table shows the SCS3000-48 pin assignment.
Ampacity of outputs:
10 x 40 A high side / low side, 5 H-bridges, PWM 20 kHz
10 x 35 A high side
28 x 12 A high side
Supply pin
Mating plug: Surlok SLPPC...BSR0 (... = size: 50 = 200 A, 70 = 250 A, 85 = 300/350 A)
Pin
Cross
section
Name
Description
1
–
+ Supply
B
Plug 1
Mating plug: TE 1-1534127-1, cap: 9-1394050-1
Pin
Cross
section
Name
Description
1
20-12AWG
Power ground
Battery -
2
20-12AWG
Output 20
High side 35 A
3
20-12AWG
Output 19
High side 35 A
4
20-12AWG
Output 18
High side 35 A
5
20-12AWG
Output 17
High side 35 A
6
20-12AWG
Output 16
High side 35 A
7
20-12AWG
Output 15
High side 35 A
8
20-12AWG
Output 14
High side 35 A
9
20-12AWG
Output 13
High side 35 A
10
20-12AWG
Output 12
High side 35 A
11
20-12AWG
Output 11
High side 35 A
12
20-12AWG
Output 10
High side, low side, low side PWM, half-bridge, full bridge, soft start
(1) (2)
13
20-12AWG
Output 9
High side, low side, low side PWM, half-bridge, full bridge, soft start
(1) (2)
