E-Tech VPPH01 Manual
7
•
Network Setting
iptype
: Set how IP phone gets relevant network parameters by selecting corresponding item from drop down list.
- static ip: Select this item to authorize users set IP address, subnet mask and router IP address of IP phone
manually.
- dhcp: Select this item to enable DHCP mode. With this system, your LAN or router automatically assigns all the
required network parameters to any device connected to it when the device log on. The E-Tech VPPH01 IP phone is
shipped from the factory with DHCP on. So, if your LAN or router is configured to use DHCP addressing, the IP
phone’s LAN parameters will automatically be configured as soon as it is connected to the LAN or router and
powered up.
- pppoe: Those ADSL and Cable Modem users please select this item for it is a protocol
especially designed for them. With this system, ADSL ISP automatically assigns all the
required IP parameters to any device connected to it when the device log on.
- modem: If the IP phone used with modem, please select this item to get relevant network
parameters auto. Then please fill ID and pin into ppp id and ppppin fields.
ppp id:
With pppoe or modem selected in iptype drop down list, please enter the user name here.