ADJUSTING THE TOE-IN
1. Place the machine on a level surface.
2. Measure:
• toe-in
Out of specification
ĺ
Adjust.
Toe-in
10 mm (0.40 in)
Before measuring the toe-in, make sure that
the tire pressure is correct.
a. Mark both front tire tread centers.
b. Face the handlebar straight ahead.
c. Measure the width
between the marks.
d. Rotate the front tires 180° until the marks
are exactly opposite one another.
e. Measure the width
between the marks.
f. Calculate the toe-in using the formula given
below.
g. If the toe-in is incorrect, adjust it.
Forward
3. Adjust:
• toe-in
• Be sure that both tie-rods are turned the
same amount. If not, the machine will drift
right or left even though the handlebar is
positioned straight. This may lead to mis-
handling and an accident.
• After setting the toe-in to specification,
run the machine slowly for some distance
with both hands lightly holding the han-
dlebar and check that the handlebar
responds correctly. If not, turn either the
right or left tie-rod within the toe-in speci-
fication.
Toe-in =
–
3 - 30
ADJUSTING THE TOE-IN
CHK
ADJ
TIP
WARNING
