DISASSEMBLING THE SECONDARY SHEAVE
1. Remove:
Install the clutch spring holder and clutch
spring holder arm
onto the secondary sheave
as shown. Then, compress the spring, and re-
move the nut lock .
CHECKING THE CLUTCH SHOE
1. Measure:
Scratches → Glaze using coarse sandpaper.
Damage/wear → Replace
Clutch shoe thickness
4.0 mm (0.1575 in)
<Limit>: 2.0 mm (0.0787 in)
<Limit>: 19.0 mm (0.7480 in)
not use them again.
3. Remove:
Remove the V-belt and clutch assembly from the
primary sheave side.
2
1
•
econdary sheave assembly
•
V-belt
•
V-belt
•
V-belt width
•
nut lock
•
clutch shoe
•
Inspect clutch shoes
.
•
After removing the clutch weight spring, do
•
Replace the all three as a set.
1
2
1
3
3
2
1
1
2
a
a
a
a
a
CHECKING THE V-BELT
1. Check:
Cracks/damage/wear → Replace.
Grease/oil → Clean the primary and sec-
ondary sheave.
2. Measure:
Out of specification → Replace.
V-belt width
20.0 mm (0.7874 in)
1
a
1
ENG
BELT DRIVE
TIP
TIP
TIP
4 - 34
