3. Check:
• tie-rod ends
Turn the handlebar to the left and/or right
until it stops completely, then slightly move
the handlebar slightly in the opposite direction.
Tie-rod end (s) have vertical play →
Replace the tie-rod end(s).
Refer to “STEERING SYSTEM” in chapter 6.
4. Raise the front end of the machine so that
there is no weight on the front wheels.
5. Check:
• ball joints and/or wheel bearings
Move the wheels laterally back and forth.
Excessive free play → Replace the front arms
(upper and lower) and/or wheel bearings.
CHECKING THE STEERING SYSTEM/
1
ADJUSTING THE TOE-IN
1. Place the machine on a level surface.
2. Measure:
• toe-in
Out of specification → Adjust.
Toe-in
10 ~ 15 mm (0.39 ~ 0.59 in)
Before measuring the toe-in, make sure that
the tire pressure is correct.
a. Mark both front tire tread centers.
b. Face the handlebar straight ahead.
c. Measure the width
between the marks.
d. Rotate the front tires 180° until the marks
are exactly opposite one another.
e. Measure the width
between the marks.
f. Calculate the toe-in using the formula given
below.
Toe-in =
–
g. If the toe-in is incorrect, adjust it.
Forward
ADJUSTING THE TOE-IN
CHK
ADJ
3 - 25
1
