OPERATION AND SERVICE INFORMATION
Page 9
Owner’s Guide
Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings.
B
B
materials will cause corrosion of underbody parts unless
flushed occasionally with plain water. Thoroughly clean
any areas where mud or other debris can collect. Sedi-
ment packed in closed areas should be loosened to
ease its removal, taking care not to chip or otherwise
damage paint.
REPAIR
LIFTING THE VEHICLE
Tool List
Qty.
Floor jack .....................................................................1
Jack stands..................................................................4
Wheel Chocks..............................................................4
Some servicing operations may require the front
wheels, the rear wheels, or the entire vehicle be raised.
To reduce the possibility of severe injury or
death from a vehicle falling from a jack:
Be sure the vehicle is on a firm and level sur-
face.
Never get under a vehicle while it is supported
by a jack.
Use jack stands and test the stability of the
vehicle on the stands.
Always place chocks in front and behind the
wheels not being raised.
Use extreme care since the vehicle is extreme-
ly unstable during the lifting process.
When lifting the vehicle, position the jacks and jack
stands at the areas indicated only.
To raise the entire vehicle, install the wheel chocks in
front and behind each front wheel. Center the jack un-
der the bagwell and place a piece of wood, approxi-
mately 2" x 4" x 12", between the jack and the underside
of the bagwell. Raise the vehicle and position the jack
stands under the frame where the leaf spring mounting
bracket is welded to the frame.(Ref. Fig. 11)
Lower the jack and test the stability of the vehicle on the
two jack stands.
Place the jack under the center front of the car just be-
hind the bumper. Raise the vehicle and position the jack
stands under the frame where the instrument panel sup-
port is attached to the frame.(Ref. Fig. 11)
Lower the jack and test the stability of the vehicle on all
four jack stands.
To raise only the front or rear of the vehicle, place the
wheel chocks in front and behind the wheels that are not
to be raised. The jack may be left under the center front
Summary of Contents for RXV Fleet Freedom Shuttle 2+2
