OPERATION AND SERVICE INFORMATION
3-17
Read all of manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings
kg) and no more than 50 lbs (23 kg) tongue weight may be attached to
the hitch. Remember that the overall capacity of the vehicle, operator,
passenger, contents of load bed and accessories must be reduced to
compensate for the trailer and load.
The range of motion of the trailer is limited by the ball and hitch. The
trailer should not be used on rough trails or over objects such as logs,
large rocks, holes, etc.
Never install baskets or extensions using the hitch receivers (front or
rear). Such items will change the performance characteristics of vehicle
and result in unsafe handling, possible roll over or vehicle damage.
VEHICLE CLEANING AND CARE
VEHICLE CLEANING
To reduce the possibility of severe
injury or vehicle damage, read and
understand all instructions supplied
by manufacturer of pressure washer.
When pressure washing exterior of
vehicle, do not use pressure in
excess of 700 psi. To reduce the possibility of
cosmetic damage, do not use any abrasive or reactive
solvents to clean plastic parts.
It is important that proper techniques and cleaning materials be used.
Using excessive water pressure may cause severe injury to operator or
bystander, damage to seals, plastics, seat material, body finish or elec-
trical system. Do not use pressure in excess of 700 psi to wash exterior
of vehicle.
Clean windshield with lots of water and a clean cloth. Minor scratches
may be removed using a commercial plastic polish or Plexus
®
plastic
cleaner available from the service parts department.
Normal cleaning of vinyl seats and plastic or rubber trim requires the
use of a mild soap solution applied with a sponge or soft brush and
wipe with a damp cloth.
Removal of oil, tar, asphalt, shoe polish, etc. will require the use of a
commercially available vinyl/rubber cleaner.
The painted surfaces of the vehicle provide attractive appearance and
durable protection. Frequent washing with lukewarm or cold water and
mild detergent is required to preserve the painted surfaces.
Occasional cleaning and waxing with non-abrasive products designed
for ‘clear coat’ automotive finishes will enhance the appearance and
durability of the painted surfaces.
Corrosive materials used as fertilizers or for dust control can collect on
the underbody of the vehicle. These materials will cause corrosion of
underbody parts unless flushed occasionally with plain water. Thor-
oughly clean any areas where mud or other debris can collect. Sedi-
ment packed in closed areas should be loosened to ease it’s removal,
taking care not to chip or otherwise damage paint.
If the engine does not start or runs improperly after
washing, remove the spark plug wires (by pulling
the spark plug boots, never the wires). Dry all connections with
forced air. Reinstall the wires.
!
!
Summary of Contents for ST 480
