E-ZTrail.com
550 Grain Cart
1
WARNING
• Do not attempt to clean, adjust, lubricate, or enter the grain cart while any part is in operation.
• Do not start the machine without all guards and shields in place, and in good working condition.
• Do not operate on public roads unless equipped with proper lighting or warning devices. It is the responsibility of
the user and owner to install lighting or other equipment as required by state and federal laws.
• Do not allow children to play on or around the grain cart.
OPERATION
•
The indicator flag in front of the auger shows the position of the inner door.
• When engaging the PTO, the door should be closed and the tractor should be running at low RPM’s to prolong
the life of the drive-line and gearbox.
• With the auger running, open the door and begin unloading grain. Do not exceed 750 PTO RPM for maximum
efficiency and auger life.
• When the cart is nearly empty, the door can be partially closed to provide better clean out.
• The top auger must remain locked in the unloading position while the PTO is engaged. Folding the top auger
while the auger is turning can cause damage to the augers.
•
Check wheel nuts for the proper torque before first use, after the first load, and then periodically afterwards.
(350ft/lbs)
MAINTENANCE
If you have further questions, please contact us at 217-543-3471.
Parts may be ordered online at www.e-ztrail.com, where you can also download additional manuals.
Grease Regularly:
►
PTO Shaft
►
U-Joint Gearbox
►
Bearing at TOP of the Lower Auger
►
Bearing at the TOP of the Top Auger
►
Auger Hinge
Recommended Tire Inflation:
PSI
23.1-26, 12 Ply..................40
Before first use, then annually:
►
Check gearbox oil level, use 90W oil.
►
Check wheel bearings for sufficient grease &
proper adjustment.
