INTERNATIONAL E-Z UP, INC.
1900 Second St., Norco, California 92860
800-45-SHADE
The #1 Instant Shelter
®
Brand in the World
ezup.com
Fig. B
Fig. A
Fig. C
Center Trusses
Leg Adjustment
Toggle Button
Auto-Slider
®
Pull Pin
Fig. D
Axle
Receiver
Wheel
Snap Clip
Fig. E
Snap Clip
TAKEDOWN
Collapse Shelter Legs
1.
With a partner, slightly lift two adjacent corner legs simultaneously.
2.
Depress the
Toggle Button
and slide lower/inner legs into upper/outer legs, making sure to do two legs at a time on
the same side.
(Fig A)
3.
Repeat on remaining legs.
Note: Keep the toggle button depressed while retracting leg.
Release Auto-Slider
®
Pull Pin
4.
With one hand, slightly push up on the truss near the
Auto-Slider
®
Pull Pin
to relieve pressure.
(Fig B)
5.
With the other hand, release the
Auto-Slider
®
Pull Pin
by pulling the ring.
6.
Repeat on remaining legs.
Closing Shelter
7.
Grasp the
Frame
on the top of the diamond-shaped area of
Center Trusses
on the opposite sides near the “CLOSE
HERE“ sticker.
(Fig C)
8.
Lift the shelter up slightly, and shake it while stepping toward your partner until the shelter is approximately 3/4 closed.
Be careful not to pinch fingers!
9.
Grasp the two outer legs, and push the frame together until it is fully closed.
10.
Store the shelter in the roller bag provided.
Note: Hug your shelter before placing it in the cover bag.
CARE AND MAINTENANCE
For long lasting durability and the best possible protection for your E-Z UP
®
Instant Shelter
®
products, follow these E-Z care
and maintenance instructions:
• Use a mild soap (not detergent) and plenty of water for top cleaning.
• Let the E-Z UP
®
top and frame dry completely before closing or storing to avoid mildew.
• Frame will operate and look better if occasionally wiped with silicone spray, especially before and after use in damp
conditions. Remove excess silicone residue before applying top.
• Use a seam sealer if top leaks or drips water. Available at most sporting goods and hardware stores.
• Slightly tighten bolts if frame becomes loose.
Replacement Parts
For all shelter sizes: Call 800-45-SHADE or go to ezup.com/parts
WARNING:
Keep all flame and heat sources away from all shelter fabrics. These fabrics meet the flammability
requirements of CPAI-84. The fabric may burn if left in continuous contact with any flame source. The application of any
foreign substance to the fabric may render the flame-resistant properties ineffective.
ROLLER BAG
One-Time Assembly
Use the Roller Bag to store and transport your Instant Shelter
®
and Spike Kit.
1.
Slide
Axle
through Roller Bag
Receiver. (Fig. D)
2.
Slide one
Wheel
onto each side of the
Axle.
3.
Push
Snap Clip
over
Wheel Axle
end (against
Wheel
).
(Fig. E)
Your Roller Bag is ready to use!