2
Qwik Install
STEP 1:
Decide if install will be VERTICAL
polarity or HORIZONTAL polarity.
STEP 2:
Decide if UPTILT or DOWNTILT
is going to be required for the particular
installation. Bracket will be attached to
back of antenna to provide uptilt or down-
tilt by rotating the bracket install orienta-
tion 180°.
DANGER! Avoid Powerlines!
You Can Be Killed!
When following the instructions in this guide to install the EZ2 take ex-
treme care to avoid contact with overhead power lines, lights and power
circuits. Contact with power lines, lights or power circuits may be fatal.
We recommend to install EZ2 no closer than 20 feet to any power lines.
Safety:
For your own protection, follow these safety rules.
▫
Perform as many functions as possible on the ground
▫
Do not attempt to install the antenna on a rainy, windy or
snowy day or if there is ice or snow accumulation at the install
site or if the site is wet.
▫
Make sure there are no people, pets, etc. below when you are
working on a roof or ladder.
▫
Watch out for any power lines which may be overhead, under-
ground or behind walls., keeping safely clear of them with the
antenna, ladders or any tools.
▫
See appendix for FCC RF exposure guidelines
Recommended Tools:
Pliers, Adjustable Wrench, Screws for
mounting Wall Mount Bracket, Drill or Screwdriver for installing
wall mount bracket, sealant for sealing any holes.
NOTE:
You
should be familiar with using tools such as these before attempting in-
stallation of EZ2. You should be comfortable with working on a ladder.
GROUNDING: Local building and electrical codes require that
the antenna be properly grounded. Improper installation may seri-
ously damage the equipment or building, as well as cause injury
or death to you. Run a ground wire 10AWG or bigger from back of
antenna to a good earth ground (Cold water pipe or metal stake in
ground)
.
