6
generated which can damage electronic equipment. We have taken
special care in the design of the EZ2 unit to ensure proper grounding of
the electronics inside the enclosure to prevent damage from electrical
storms. Make sure that the POE Power Supply is plugged into a surge
protected outlet such as a surge protected power strip or UPS inside
the house.
5.
PAINTING
– The EZ2 unit can be painted to match a particular house
color. Only non metallic enamel or latex paints should be used. If a
paint with metal content is used, it will block the microwaves and cause
reduced performance.
Appendix:
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be deter-
mined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for
help.
•
FCC Caution: Any changes or modifications not expressly ap-
proved by the party responsible for compliance could void the
user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is sub-
ject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
