Eachine E013, User Manual

10.0. Flying environment

9.2 One key return

One key return

Press the button to return to the channel, you can correct the way through 

the right joystick to correct the channel (to the front of the frequency before 

the start in order to return to normal), the aircraft will automatically return.
During the return process, press the function key combination on the remote 

control or push the right joystick "forward" to return the aircraft.

Do not use this product in the following environments to 

avoid accidental injury or damage to the aircraft.

1) high-voltage line lots, park lots, railway lots, highway lots and so on

2) thunderstorms weather, windy weather, rain and snow weather.

Decline

上升

Rise

Forward 

Backwards

Turn right

Turn left

Fly on 

the right

Fly on 

the left

10

12

14

08

9

11

13

07

15.0. Accessories list

INSTRUCTION MANUAL

Aircraft x1

USB charging cable x1

Propeller Ax3
Propeller Bx3

A

B

LiPo battery x1

Remote control x1

Manual x1

Screwdriver x1

7.2 Operation mode

Up 

Down

Forward

Backwards

Left Right 

Fly on 

the left

Fly on 

the right

Aircraft movements fine-tuning

Slowly raise the throttle stick, when the aircraft to 

leave the ground, if the aircraft tend to different 

directions, you can use fine-tuning correction action.

1. Adjust the front and rear fine adjustment

When the aircraft leaves the ground, the aircraft is 

moved forward / backward, forward, and the fine 

adjustment is adjusted downward.

When you move backwards, fine tune upwards.

2. Adjust the aircraft side fly fine tuning

When the aircraft leaves the ground, flying 

to the left / right side of the side fly.

Fly to the right, fine-tune the left to adjust.

Fly to the left, fine-tune the right to adjust.

Tips: 

Before the aircraft take off, be sure to place the aircraft in the 

horizontal plane proofreading, to ensure that the aircraft after the smooth 

flight. When the aircraft by the impact or collision after the deviation, you can 

also use this method to calibrate the gyroscope.

7.0. Operation and control

7.1 mode of operation

As sensitive, for beginners, it is recommended to slow operation of the rocker. 

Such as the operation of the aircraft during the process of a slight decline, but 

also slowly push the left rocker to climb to a certain height. Operation to avoid 

a significant push of the throttle.

8.0. 360 ° rollover

8.1  Left 360 ° roll

Short press the scroll 

key, and then push the 

right lever to the left, the 

corresponding aircraft to 

the left flip 360 °

8.2 Right  360 ° roll

Short press the scroll key, 

and then push the right 

lever to the right, the 

corresponding aircraft to 

the right flip 360 °

8.4 Back 360 °roll 

Short press the right scroll 

key, and then push the 

right lever down, the 

corresponding rear side of 

the aircraft turned 360 °

8.3 Forward 360 °roll

Short press the scroll 

key, and then push the 

right lever up, the 

corresponding forward 

side of the aircraft 

9.0. Headless mode

9.1 Headless mode switching

Start and set: 

After the completion of the aircraft frequency, the aircraft placed in the 

flat level, or hover in the air to ensure that the head of the aircraft and the remote 

control in front of the same direction, press the headless mode button (aircraft LED 

lights flash) Start headless mode.

Exit the headless mode: 

Press the headless mode button again (the aircraft LED is 

lit), then exit the headless mode.

Note: Keep the aircraft at a height of 2-3 meters when rolling, so that the aircraft is 

easier to maintain the height after rolling.

Operating

F

B

R

L

Before and after

Orientation

Headless mode

F

As shown in the figure above, in the headless mode (the aircraft LED is in a flashing 

state), regardless of where the aircraft is located in front of the location, now the 

remote control is located in the rear of the aircraft, then pull down the direction of the 

operating lever You can recall the aircraft, push up the direction of the rod so the 

aircraft will fly farther away.

12.0. Propeller installation method

13.0. roubleshooting

A

A

B

B

Camera

A

13.1 remote control and the aircraft did not 

respond to the solution:

1) Make sure the code is successful. See page 

    4 for the code method.
2) whether the battery is low.
3) Make sure the remote control is the 

    original match.

13.2 Can not roll the solution:

1) Restart the rollover function key.
2) Check whether the lithium battery is too low, 

    re-charge.

13.3 aircraft fuselage solution:

1) Check if the propeller is deformed and replace 

    the new propeller.
2) turn off the aircraft power to restart.
3) Place the aircraft in the horizontal plane to 

    recalibrate the gyroscope.

13.4 Aircraft can not take off the solution:

1) Check that the screw is installed correctly.
2) whether the aircraft crash cover is loose, hinder  

     the propeller rotation.
3) whether the aircraft has electricity, 

     low power, the lights flashing.

Install the propeller: Hold the small hat of the 
propeller, press the motor shaft to press it, be 
careful not to deform the propeller.

14.0.  FPV Troubleshooting

14.2 Goggle received the image signal quality is poor or 

wireless transmission distance near:

1) whether the same frequency of radio transmission 
    equipment interference, FPV system should choose other 
    frequencies, to avoid the interference frequency or to 
    avoid the use of the same site.
2) Whether the goggle antenna is installed.
3) whether the goggle and the aircraft between the 
    mountains, houses, trees and other obstacles, please 
    use the FPV system in the open space.

14.1 Goggle display screen No image:

1) Check to see if the power supply of the 
    goggle and the power supply of the aircraft
    is normal, battery power is sufficient.
2) Check whether the goggle receive channel 
    and transmitter channel is consistent.
3) Check the transmitter and the end of the 
    goggle N / P standard is consistent.

FPV six-axis aircraft operating instructions

The main structure of the ABS material, the new 

industrial and modular design, improve product 

development, easy installation and maintenance, 

replacement upgrades.
Equipped with FPV 5.8G map transmission 

real-time transmission system, bring you not the 

same visual effects.

1. Aircraft shell
2. Cover the screw hole
3. FPV system
4. EVA pad (fixed camera)
5. Rack
6. Rack cap screw hole
7. Forward rotation propeller
8. Reversing the propeller
9. Propeller guardrail
10. Body battery compartment
11. Battery 

1.0 Know your aircraft

1.1 The architecture of the aircraft

4.0. remote control

4.1 Remote control function

      introduction

4.2 Remote control 

      battery installed

H/M/L Speed

Metal joystick

Headless mode

Throttle putter

 (up and down left and 

right steering function)

One key return button

Left rotation fine tuning

Right spin fine tuning

Switch Left fine key Right trim key

Fine-tuning key

Pre-fine key

Indicator light

Rolling keys

Directional putter 

(front and rear left 

and right side fly)

"Di" pattern for H

"Di Di" pattern for M

"Di Di Di" pattern for L

3 Different Speed Modes:  High, Medium 

And Low Speed Self-Tuning

02

04

06

01

03

05

2.0 parameters

Main wing length: 66mm
Size: 83.5*83.5*42.2mm
Weight: 20g(without battery)
Motor: 6015 1S brush motor
Lipo battery: 3.7V 200mAh 35C
Flight time: 5min
Omnidirectional reception antenna
Working temperature:-10

℃

 to +40

℃

Craft parameter

83.5 mm

42

.2

 mm

83.5 mm

83

.5

mm

5.8G 25mw map 

transmission transmitter

6015 1s brush motor

5.8G 3dBi miniature antenna

30mm propeller

Lipo battery

3.7V 200mAh 35C

(The bottom of the aircraft)

1000TVL M7 Lens

120°FOV H170°

Wide angle camera

Batt

er

y

3

2

2

8

8

7

7

4

5

6

6

9

9

9

11

10

1

Frequency Table 

Unit:MHz

                   CH1      CH2         CH3       CH4         CH5        CH6          CH7         CH8
Band 1       5865       5845        5825      5805         5785        5765         5745        5725
Band 2       5733     5752        5771      5790         5809        5828         5847        5866
Band 3       5705     5685        5665      5645         5885        5905         5925        5945
Band 4       5740     5760        5780      5800         5820        5840         5860        5880
Band 5       5658     5695        5732      5769         5806        5843         5880        5917

Key functions:

1

、

Short press the button to adjust the frequency 

function, and at the frequency FR1-FR8 cycle 

between the switch.
2

、

Long press the button for 2 seconds (LD1 

flashing when the release button) for the 

adjustment frequency group function, and in the 

frequency group CH1-CH5 cycle between the 

switch.
3

、

Long press the button for 5 seconds (LD1 from 

flashing to off when the release press key) to 

adjust the standard function, P system LD2 

flashing, N system when LD2 long bright.

1 2 3 4 5 6 7 8

A B C D E F G

CH1 

indicator

FR1

indicator

Button

LD1

time indicator

LD2

N / P indicator

P system flashes

N system long bright

Antenna

3.0 Frequency method

Button

Antenna

CH2

indicator

CH3

indicator

CH4

indicator

CH5

indicator

FR2

indicator

FR3

indicator

FR4

indicator

FR5

indicator

FR6

indicator

FR7

indicator

FR8

indicator

360 ° roll

One key return

Headless 

mode

F P V

Size of the

 amount of control

1

2

3

2.4GHz

Safe flight

Six axis 

gyroscope

6.0.Operational guidelines

6.1 Boot program

Batt

er

y

Batt

er

y

Red line

(positive electrode)

Black line

 (negative )

6.1.1. 

The battery into the fuselage battery compartment, then the 

battery port access to the fuselage power port, and placed on the 
level, then the aircraft taillight flashing, open the remote control 
power switch, remote control issued a "tick" sound, then remote 
control The remote control gives a "beep" once again, and then 
the remote control indicator is turned on again. At this time, the 
remote controller will be issued again. Bright, the aircraft LED light 
is always bright, said the completion of the code.

6.1.2. After the 

completion of the 

aircraft on the 

code, to promote 

the left joystick 

throttle can start 

the aircraft.

5.0.Aircraft Lipo  battery 

      charging

Battery

Plug the USB plug into the USB port of the computer (or the 

charger of the USB port with the DC5V output). At this time, 

the USB charging port has a red indicator light and the 

battery is connected to the USB charging cable. When the 

red light is off, it indicates that it is charging. Charging time 

30-40 minutes. To ensure safety, be sure to do so within 

sight.

FPV system :5.8G 40CH
See Table 3 on the frequency table

Please use 3 "AAA 1.5V" 

batteries and assemble 

them in positive and 

Unscrew the screw and 

open the battery cover

Close the battery cover 

and screw it on

6.2 Gyroscope proofreading

After the completion of the code, the aircraft 

placed in the horizontal position,

Push the two joysticks at the same time to the 

lower right corner 45 ° for gyro calibration. LED 

lights flash quickly, proofreading is complete.

When the left joystick (throttle) is pushed 

up or down, the aircraft rises or falls 

accordingly.

When the right operating lever 

(direction) is pushed up or down, the 

aircraft forwards or retracts accordingly.

When the left joystick (throttle) is pushed 

left or right, the aircraft turns left or right 

accordingly.

When the right-hand lever (direction) is 

pushed to the left or to the right, the 

corresponding side fly or fly on the right 

side of the aircraft.

The aircraft can do 360 ° rollover by the following 

joystick operation.

Tips: low alarm

When the aircraft appears tapping flashing, indicating that the aircraft is 

about to run out of power, then the aircraft

Will automatically turn off the trick, the aircraft in the conventional 

control state, the maintenance time of 30 seconds.

①

 manual landing.

②

 first turn off the power of the aircraft, and 

    then turn off the remote control power.

③

 Remove the aircraft from the aircraft.

11.0. End flight

The propeller of the aircraft is installed with the 

location requirements, please press the corresponding 

code to install,coded as shown below.

AGES 14+

      Tips:

The use of high 

toughness coated  

explosion-proof .It 

will be better to tear 

the film before use.