- 8 -
- 9 -
Antenna
One key take off
Throttle Joysticks
Long press to stop
Direction Trim
Power switch
Aileron Trim
Elevator Trim
Aileron Elevator Joystick
Hover mode
LED Display
(Press this key MODE2/MODE1 to convert)
ABOUT REMOTE CONTROLLER
RIGHT HAND THROTTLE
LEFT HAND THROTTLE
1. Put the throttle joystick to the bottom position.
2. Turn on the transmitter.
3. Install the battery into the rack and connect it properly with the receiving power.
4. Once the battery is connected, the signal starts to blink. Keep it still and wait until the
signal light stops blinking,which means the receiver has completed self-inspection and
gets ready for flight.
FLIGHT BATTERY INSTALLMENT
TROUBLESHOOTING
LEDon receiver flashes
constantly with no responses
after conxssting batteries to
transmitter.
The helicopter has no
response after connecting
batteries to receiver.
When push the throttle
pole, the rotor do not
rotate and the LED on
Receiver flashes
constantly.
Helicopter takes off
immediately, once
the batteries and
receiver connected.
Turn on the helicopter after
binding successfully, the
propeller rotate constantly
but the helicopter can not
take off.
Low charge in aircraft
batteries or main
gear loose.
Transmitter is not bound
to receiver.
Pairing of the transmitter and
receiver failed.
Check whether the
transmitter and
receiver connecting
to power; check the
voltage of transmitter
and receiver; Battery
pole flake contact is
not good.
Low battery voltage;
batteries connection
is not good.
Didn't put the throttle to
the lowest
Re-pair (Refer to P.5,
Programming your
Transmitter)
Open the transmitter,
make sure the batteries
connecting is good
Replace and charge
transmitter batteries
Make sure the battery
pole flake contact is good.
Replace and charge the
batteries, reconnect the
batteries to the receiver
board.
Put the throttle pole at
the lowest position
before open the
transmitter.
Replace and charge the
batteries ; press the
spindle with gear tightly.
Problem
Solution
Cause
1
2
3
4
5
Rudder Switch
