Aircraft initialization detection
After signal connection, the aircraft enters into initialization detection procedure with front and rear
lights flashing red, green and yellow alternatively. Make sure that the aircraft is set on a flat and still
surface for the initialization detection.
The aircraft initialization detection takes about 8 seconds. Once
the remote controller sends out “Di Di” sounds and the aircraft front and rear lights flash yellow
alternatively
, initialization detection is completed.
!
● Signal connection is done once for all if the remote controll
er is not linked to other
aircraft.
● Set the connection one by one to avoid signal connection erro
r.
● Power on the aircraft (Pic. 2).
The aircraft will make beep sounds with front and rear lights flashing
and will automatically link to the remote controller. Once the remote controller sends out a long beep
sound and the indicator light of the remote controller turns from flashing to solid on and the signal
icon “ ” is shown on the LCD screen, it means that signal connection is succeeded.
Pic. 1
Pic. 2
Signal connection between the aircraft and remote controller
● Keep pressing the red button “ ” and turn on the remote controller (Pic. 1).
The remote controller
makes 2 beep sounds, and the indicator light “
” keeps flashing; the remote controller is under
signal connection status.
Aircraft Operations
1.
The aircraft, remote controller and mobile device are full charged;
2.
The propellers are installed correctly;
3.
The arms and propellers are unfolded;
4. Ensure the camera lens are clean;
5. Use only Eachine parts or parts certified by Eac
hine. Unauthorized parts or parts not from Eachine
certified manufacturers may cause malfunction or safety issues.
Pre-flight Checklist
-23-
EX3 User Manual
