5.0 Switchable VTX
-8-
In the POR mode, POR FREQ: can enter into any frequency
between 5300-5900, as shown in Figure 1.4.
Figure 1.4
STATX: status information
XMM-VTX is operated by a button with three LED lights (red
light CH1-8; blue light BAND1-5; green light power 1-3 <25-
100-200 mW>)and TBS Smart Audio remote control operation.
Keyboard operation: Long press 3S (three LED indicators are
all on) to open and enter CH switching operation, and the red
light will flash, flashing once represents the currentCH1 (2-8
times for CH2-CH8 respectively). At this time, a short press of
the key CH plus 1 will flash the corresponding number of times.
CH1-8 cycle. Press the button 3S (three LED lights are all on)
to open and enter the BANDswitching operation, and the blue
light will flash. The flash once represents the current BAND1
(2-5 times for BAND2-BAND5 respectively). At this time, press
the button BAND plus 1, and the blue light will flash correspondingly.
BAND1-5 cycle. Press the button 3S (three LED lights are all on)
again to open the power switching operation, and the green light
will flash, one time represents the current power of the first grade
(2-3 times for the green light flashing respectively), at this time,
press the button power to add one gear, and the green light will
flash the corresponding number of times. Power stall 1-3 cycle.
Press the button 3S again (3 LED lights are all bright) to release
the above settings again. Note that the previous settings will not
be saved if the power is off before saving. For example, if CH is
only set, it is also necessary to press 3S three times longer to
save the settings.Long press button 8S (green light) quit PIT mode.
<2>
TYRO79
QUICK START GUIDE
