Installation, Operation and Parts Manual
EE-6435V2.S/EE-6435V2.B
25
5.4 Operation instructions
The lift must be only used in a static position for lifting and lowering vehicles.
Only use this lift on a surface that is stable and capable of sustaining the load. Do not install the lift on any asphalt sur face.
To avoid personal injury and/or property damage, permit only trained personnel to operate the lift. After reviewing these
instructions, get familiar with lift controls by running the lift through a few cycles before loading vehicle on lift ing platform.
Raise the lift
Make sure vehicle is neither front nor rear heavy and center of balance should be centered over the lift.
1. Turn on the power switch.
2. Park the vehicle on the platforms to ensure its gravity is positioned midway of the platforms.
3. Push the UP button until rise to the expected height.
4. Before perform any service around or under the vehicle, push the safety lock button to ensure the mechanical safety lock is fully engaged.
Turn off the power so as to avoid any wrong operation done by irrelevant personnel and check again the stability of the vehicle.
Lower the lift
Pay careful attention that all personnel and objects are kept clear.
1. Turn on the power switch.
2. Push “DOWN I” button to lower the lift. It will stop lowering at proper height off the ground.
3. Push “DOWN II” button to continue lowering the platforms which accompanies with safety alarming buzz.
5.5 Emergency lowering in case of no power
In the case the safety lock is not engaged
：
1. Push the front rod of the four electromagnets under the cross beam to have the four safety blocks released from the safety rods.
2. Push and turn counterclockwise the unloading valve to lower the platform.
Unloading valve
Safety block and safety rods
Front rod of electromagnet
Summary of Contents for EE-6435V2.B
