c.
Host IP
After the setting is finished, press Play key to enter system setting.
Step 2:
If the setting is successfully finished, the system will display the set result in Test OK and
Show Net info interface. The information of Ad-Hoc is recorded here, such as SSID, safety
mode, IP address, subnet mask and preinstall gateway. Press the enter key to complete the
setting.
If obtained the IP address failed, please return and try it again.
8.3.2.3 WPS
(
AP
)
Connect wireless network card with the system and carry out the following operations.
After WPS (AP) way is selected, press the enter key to enter setting page.
There are two connection ways: button setting (PBC) or individual information code (PIN
code).
a.
PBC (Push Button)
After PBC mode is selected, press the enter key for confirmation and the system will
automatically get the IP.
If the setting is successfully finished, the system will display the set result in Test OK and
Show Net info interface.
If obtained the IP address failed, please return and try it again.
b.
PIN code
After PIN method is selected, press the enter key for confirmation and the system will
automatically get the IP.
After the setting is successfully finished, return to network setting interface. The
connection mode, IP address and signal intention will be displayed on the right side of the
screen. (Note: AP means AP mode has correctly run; AD HOC means AD HOC mode has
correctly run.)
Helpful tips: