Eagle Eye Power Solutions SG-100M User Manual Download

Page: 1 / 3

SG-100M Input Voltage Adjust

This guide will outline the steps necessary to change the input voltage between 115VAC or 230VAC. A

soldering kit and skills required for soldering will be required.

1.0 Disassembly

1. Disconnect the main power.

2. Open the SG-100M by removing the two screws on the bottom of the unit as shown in red.

3. Remove the Omega Panel Meter from the SG-100M housing as shown in red.

Eagle Eye Power Solutions, LLC

| Tel: 1-877-805-3377 | Fax: 1-414-962-3660 |

www.eepowersolutions.com

V1.0

Summary of Contents for SG-100M

Page 1: ...kills required for soldering will be required 1 0 Disassembly 1 Disconnect the main power 2 Open the SG 100M by removing the two screws on the bottom of the unit as shown in red 3 Remove the Omega Pan...

Page 2: ...red AC line L 6 Lift the back of the main PCB board upwards and let it slide out of the black plastic case 7 Locate the three power jumpers W1 W2 W3 on the side of the board Eagle Eye Power Solutions...

Page 3: ...is 230 VAC solder jumper W2 should be wired but jumpers W1 and W3 should not W4 jumper is not used 9 Solder the correct power jumper for the input voltage desired 10 After the soldering complete re a...

Brands by name