Eagle Eye Power Solutions SG-100M User Manual Download

Page: 2 / 3

4. Remove the back case cover of the Omega Meter by pulling up.

5. Disconnect the red AC line “L”

6. Lift the back of the main PCB board upwards and let it slide out of the black plastic case.

7. Locate the three power jumpers, W1, W2, & W3 on the side of the board

Eagle Eye Power Solutions, LLC

| Tel: 1-877-805-3377 | Fax: 1-414-962-3660 | www.eepowersolutions.com

Rev. 03.14.A

Summary of Contents for SG-100M

Page 1: ...kills required for soldering will be required 1 0 Disassembly 1 Disconnect the main power 2 Open the SG 100M by removing the two screws on the bottom of the unit as shown in red 3 Remove the Omega Pan...

Page 2: ...red AC line L 6 Lift the back of the main PCB board upwards and let it slide out of the black plastic case 7 Locate the three power jumpers W1 W2 W3 on the side of the board Eagle Eye Power Solutions...

Page 3: ...is 230 VAC solder jumper W2 should be wired but jumpers W1 and W3 should not W4 jumper is not used 9 Solder the correct power jumper for the input voltage desired 10 After the soldering complete re a...

Brands by name