Eagle power FASTRACTS SC12, Operation And Parts Manual

I

•

Use defoamer at all times to prevent damage to the vacuum motor(s).

•

Do not use water in excess of 140°F (62°C).

•

Use only commercially available carpet cleaners and defoamer intended for use with
machines of this type. Do not use dyes, bleaches, ammonia or other additives. The use of
powdered cleaning solution if not diluted properly made result in damage to the pump.

•

Do not expose machine to freezing temperatures.

•

All repairs must be done by an authorized Eagle Power repair station.

•

Do not use replacement parts other than those specified in the parts list.

FAILURE TO COMPLY WITH THE ABOVE WARNING INSTRUCTIONS WILL VOID THE
WARRANTY.

GROUNDING INSTRUCTIONS

The 120 V. A/C and the 220 V. A/C models have been outfitted with the appropriate grounded
connectors. Make sure the machine is connected to a grounded outlet having the same configuration
as the grounded plug. No adapter should be used with this machine. Any modification to the connectors
will void the warranty.

PREPARING THE MACHINE

1. Rinse then fill the recovery pail with clean hot tap water (not to exceed 140°F). When pouring

water, make sure drain hose is clipped in the upright position. Pour the water into the solution
tank.

2. Add recommended amount of cleaning solution to the tank, follow mixing directions on label for

best results.

3. Set the recovery pail back in place. Add recommended amount of defoamer to the recovery

pail. Close the lid.

TO CLEAN CARPET

1. Connect machine to a grounded electrical outlet.
2. Turn on the VACUUM, PUMP and BRUSH switches.
3. Lift up on the handle grips to insure that the front of the machine rests on the carpet. Slowly pull

the machine backwards while pressing on the carpet spray switch (below the left handle grip).
Monitor the extraction process through the vacuum lid. Release the spray switch 6 inches before
ending the stroke.