INSTALLATION OPERATING & MAINTENANCE INSTRUCTIONS
Gas Fryer (NG Unit)
5
(continued on next page)
/ .
-
9
<
;
=
0
<
;
=
E
E
!
%
%
/ .
-
9
<
;
=
0
<
;
=
E
E
!
%
%
Step 3.
Turn the Gas Control Valve dial to “Pilot” position and press and hold. Press the pilot
ignition button. If the unit does not light, continue pressing and holding the pilot button
and press the ignition button again. Purging air from the system may take 5–7 minutes on
first use.
Step 2.
Ensure the thermostat dial is at the “OFF” position.
Operating Instruction:
Step 1.
Ensure this Gas Control Valve dial is at the “OFF” position.
LIGHTIING INSTRUCTIONS
Fryers are furnished with a Gas Control Safety Valve. Please follow the instructions below.
Before Lighting Pilot and Burners
Fill the fat tank about 3/4" below the full line with proper frying compound before lighting pilot. The
reason for filling the tank 3/4" below the full line is that the frying compound will expand during the
preheating process.
If the frying compound expands above the full line, the frying compound may overflow out of the tank
during the cooking process. The reason for adding fry compound in fry tank before lighting the pilot
or burners is that the unit will be damaged if this is not done.
