NEVER WELD, DRILL, OR CHANGE
THE AIR RECEIVER IN ANY WAY.
Any replacement parts should be purchased with the same specifications
as the original equipment. Please contact the authorized dealer
for replacement parts or specifications.
SAFETY VALVE
This valve is factory installed to prevent over pressurizing of the air receiver.
It is factory set at a specific limit for your particular model, and should never
be tampered with.
Adjustment by user will automatically void the warranty.
DO NOT REMOVER, MAKE
ADJUSTMENTS TO OR
SUBSTITUTE THIS VALVE!
INSTALLATION
1. INSTALLATION
Proper care and maintenance ensure longevity. Do not over tighten foot bolts
as excessive vibration may occur. Use only in a clean, dry, and well-ventilated
area. The compressor has heat dissipation fins for proper cooling. Keep
the fins and other parts that collect dust clean. Do not place rags or other
materials on top of the compressor, as this obstructs cooling and can be a
fire hazard.
2. BREAK-IN PROCEDURE
Before anything is hooked up, run the compressor 15 minutes with the
drain valve open. After the compressor has run for 15 minutes
continuously, the unit is ready to use.
3. BEFORE OPERATING THE AIR COMPRESSOR, PLEASE
CHECK THE FOLLOWING CAREFULLY:
1. Check to see that nuts and bolts are all snug.
2. If the intake filters are dirty, they should be replaced or cleaned.
4. COMPRESSOR LUBRICATION
These units are oil free. Lubrication is not required.
Page 5
Summary of Contents for silent series
