- 5 -
3. Machine Setup and Installation
TAKE CARE TO AVOID DAMAGE TO THE MOTOR AND ASSEMBLY
WHILE LIFTING OR TRANSPORTING THE MACHINE!
3.1 Transportation
Use a fork lift or tow motor to remove the machine from its shipping container or pallet.
3.2 Working Height Adjustment
While elevated, install the 4 casters onto the legs. Set each leg to the same height to ensure the
machine is level when placed onto the ground.
The working height should be set such that the operator is able to comfortably reach the roller table
while maintaining approximately 4in (100mm) of distance from the machine.
3.3 Tape Head Installation
Rest the upper tape head on the carriage placing the notches in the rear of the tape head onto the
supporting shaft. Pull out the pin rod by the key ring, lower the tape head and release the key ring.
For the lower tape head, remove the front supporting shaft. Rest the rear of the tape head on the
rear supporting shaft. Place the front supporting shaft on the angled notches in the front of the tape
head and lower the tape head down guiding the pin into the notches in the frame.
Check tape cutter position and adjust as needed.
Summary of Contents for T100
Page 16: ...16 6 Illustrations Parts List 6 5 Side Conveyor System...
Page 26: ...7 Electrical Schematics 26...
Page 27: ...27 7 Electrical Schematics...
Page 28: ...28 7 Electrical Schematics...
