KIT
REV
2. Press [KIT REV ON/OFF] key to enter into drum selection.
The display shows drum kit number and the KIT LED lights
up. Use [-DATA+] button to select drum kit.
Preset drum kit: KIT01---20
User drum kit: USER01---10
3. Press [KIT REV ON/OFF] button to enter into reverb setting.
LED shows the reverb effect. Use [-DATA+] button to switch
the reverb effect (use the reverb effect to make the sound
fuller)
Pad parameter setting
Press [VOICE VOL/PAN/TUN] key to enter into the pad param-
eter setting and then enter into voice, level, pan, tuning.
VOICE
LEVEL
PAN
TUNING
Select pad voice
Voice: the module has 250 voices. Please refer to the voice list.
1. Press [VOICE VOL/PAN/TUN] button for the first time to
enter into voice setting. The display shows the current pad
voice and the voice LED lights up.
2. Strike the pad of which voice to be changed. Use [-DATA+]
button to select the voice (voice Number:001-250” non-
recycle)
Adjust pad volume
1. When adjusting the pad volume, press once again [VOICE
VOL/PAN/TUN] button to enter Into pad volume setting.
The first LED shows r LJ , and the other two LED shows the
volume Value. VOICE LED lights up.
2. Strike the pad of which volume to be changed. Use [-DATA+]
button to select the volume (00-32 non recycle).
Pad pan
1. Press [VOICE VOL/PAN/TUN] button continuously to enter
into the pan setting. The display displays letter “P” first and
then the pan value. The VOICE LED lights up.
2. Strike the pad of which the pan to be adjusted. Use [-DATA+]
button to adjust the pad pan C ±8, non-recycle)
Pad tuning
This function is used for tuning the pad
1. Press [VOICE VOL/PAN/TUN] button continuously to enter
into pad tuning. The display displays letter “t” , and then the
tuning value. VOICE LED lights up.
2. Strike the pad to be tuned. Use [-DATA+] button to adjust
pad tuning C ± 2 , non-recycle)
Establish user drum kit
In the drum kit menu, user can select the preset drum kit to
play, or user can select the pad voice and relative parameters,
e.g. voice, volume, UR pan, tuning.
This module has 30 drum kits:
Preset drum kits: KIT01---20
User drum kits: USER01---10
1. In the drum kit menu, press [SAVE] button to enter into user
drum kit setting. Use [-DATA+] button to select the user
drum kit C U01-U 1 O” non-cycle) . During this process, the
drum kit number flashes.
2. Press the pad parameter setting to change the pad tone/
volume/pan/tune.
3. Press [SAVE] button once again to save the drum kit setting,
and the former drum kits will be covered by the new drum
kit. The drum kit number stops flashing.
Note: if the drum kit number has been changed or the power
fails before saving, the former drum kit parameters will be lost.
Song setting
Select song
1. Press [SONG] button to enter into song setting. The display
EAGLETONE E-TOUCH ELECTRONIC DRUMS
User’s manual english
12
U
VOICE LIST
