20. Set the module stand to proper position.
21. Screw down.
22. Adjust the balance of the drum stand.
23. Tighten all the screws at the collars. Tighten the clip screw.
Assemble the pads
1. Take out the pads ( 3 tom and 1 snare) . Loosen the square
screw.
2. Assemble the pads onto the tubes and adjust the position.
3. Tighten the square screw.
Assemble the cymbals
1. Loosen the butterfly nut on the left side of the Hi-Hat.
2. Assemble the Hi-Hat cymbal.
3. Tighten the butterfly nut (Note: don’t overtighten)
4. Loosen the butterfly nut on the cymbal rod.
5. Assemble the Crash/Ride cymbal onto the rod.
6. Tighten the butterfly nut (Note: don’t overtighten)
Assemble the module
1. Loosen the square screws of the module.
2. Assemble the module onto the module stand.
3. Screw down.
Tighten the square screw.
Assemble the bass drum
1. Take out the bass drum and bass drum stand
2. Loosen the square screw of the bass drum
3. Assemble the bass drum on the stand
4. Tighten the square screw.
User’s manual english
EAGLETONE E-TOUCH ELECTRONIC DRUMS
7
GETTING READY TO PLAY THE DRUMS
O
